thermal quenching

Proton uptake of chloroplasts and the fluorescence quenching of 9_aminoacridine ( 9_AA) in thylakoid membrane decreased after the thermal pretreatment, but addition of dicyclohexylcarbodiimide ( DCCD) could partially restore the fluorescence quenching of 9_AA.

叶绿体的9氨基吖啶（9AA）荧光猝灭减弱，但加二环己基碳二亚胺（DCCD）可以部分恢复9AA荧光猝灭。

The Theoretical Model of the Thermal Stress Evolution Mechanism during Quenching of no Phase Change Alloy& ( 1) The Corner and Edge Model for Thermal Stress during Quenching and the Corner Effect during Quenching

无相变合金淬火热应力演变机理的理论模型&（1）角端和边缘淬火热应力模型与淬火角端效应

The tempering curve of remaining thermal quenching is higher than that of two times quenching.

余热淬火的回火曲线高于二次淬火的回火曲线；

Thermal activation and radiation quenching effects in pre-dose dating of porcelain

前剂量中的热激活和辐照熄灭研究

The development of thermal damage with increasing quenching tempera-ture difference for three types of Al_2O_3 ceramics has been investigated.

研究了三种Al2O3陶瓷的损伤状态随热震温差变化的趋势。

The thermal quenching of Er PL tends to decrease with an increase in the N concentration in Er doped a-Si: H.

随着N掺杂浓度的增加，Er PL的热猝灭效应下降。

Exploition and Application of Quenching Equipment of Remnant Forging Thermal Quenching for Automotive Axle Tube

汽车轮毂轴管锻造余热淬火装置的开发与应用

Using differentiated thermal analysis quenching method, the solidification process of CG cast iron with various percentage of compacted graphite particles is investigated.

本文应用微分热分析液淬法研究了不同蠕化率蠕铁的一次结晶过程。

In this paper, 3 types of surface modes and 2 types of center modes and their practical applications were proposed and analyzed for the thermal stress analysis during quenching for no phase transformation alloy.

建立并深入分析了3种表层淬火热应力模型和2种内部淬火热应力模型及其实际应用。

The Er PL thermal quenching is restricted due to the large mismatch between the Si-nc bandgap energy and the Er transition energy.

利用Si-nc带隙和Er~（3+）跃迁能量之间较大的不匹配可以抑制温度淬灭效应。

The behavior of these centers for various thermal quenching and anne-aling procedures provides evidence that these hole traps result from supersaturated vacancy, and probably are related to a certain large vacancy cluster.

从这些深中心缺陷的不同淬火和退火行为，可以认为缺陷中心主要是样品在激光退火过程中产生的过饱和空位所形成的，而且可能是与某种大空位团有关。

Abnormal temperature dependence of UV emission integrated intensity of ZnO and ZnO: In samples is observed. The mechanism of the negative thermal quenching was investigated.

在变温PL光谱中，ZnO和ZnO：In晶体的紫外发射积分强度出现反常的负热淬灭现象，研究了这种非单调的温度依赖现象产生机理。

The good isothermal quenching process is austenitizing at 800 ℃ and thermal quenching at 280 ℃ for 3 hours.

该钢理想的等温处理工艺为800℃奥氏体化+280℃等温3h。

Numerical analysis of temperature and thermal stresses fields in quenching 7075 aluminum alloy thick plates

7075铝合金厚板淬火温度场及热应力场的数值模拟

This paper briefly introduced the mechanism of charge transfer luminescence in scintillators containing Yb3+ ions, and the host effect on the thermal and concentrations quenching.

本文简要介绍了掺Yb3+闪烁晶体的电荷迁移发光的机理以及基质晶体对温度猝灭与浓度猝灭的影响。

The thermal quenching of PL intensity for samples annealed at 900 ℃ measured at temperatures from 15K to 300K is 30%.

测量温度从15K变化到300K时，样品（900℃，30min退火的GaN：Er）的1540nm处PL温度猝灭为30%。

Research for Thermal Characteristics in Coke Drying Quenching Boiler with High-pressure and Natural Circulation

高压自然循环干熄焦余热锅炉热力特性研究

The ion-implantation damage defects and thermal stress during quenching step are responsible for the formation of dislocations.

位错的形成与离子注入引进的损伤和淬火过程中的热应力有关。

With the Ba 2+ substitution for the Ca 2+ or Sr 2+ into the crystall, the luminescence properties of Eu 2+ has changed: the emission peak lowered and the thermal quenching temperature increased.

当用Ba2＋离子代替Ca2＋或Sr2＋离子进入晶体时，Eu2＋离子的发光特性发生改变：发射峰的峰值降低，热猝灭的温度升高。并采用位型坐标理论给予解释。

For miniature lamp, it is most important to improve the thermal quenching.

在紧凑型节能荧火灯中热猝灭的改善是十分重要的。

The amount of thermal induced ε martensite increased as quenching temperature increased.

淬火加热温度越高，热诱发ε马氏体数量越多。